Ubiquiti ap not powering on.
Ubiquiti ap not powering on 3af/at/bt PoE, it will not damage the AP; as you said, it performs a handshake and only sends a significant amount of power if the device requests it, which a Ubiquiti 24V AP will not. Changed out upstairs AP itself, moved ports, changed wires, etc. The camera is the only Community, I just recently bought the the AC-LITE from a reseller of UBNT to reduce my cost on meraki licensing for home use. For the first 3 it's been the same experience as your edit - the replacement units always work fine in the same location with the same cables, and swapping the APs around results in the issue universally following the AP, not the cable, port, or injectors (when applicable). Here is what I tried: Replugged the cable to the POE injector Replugged the cable to the AP Tried another switch port - no link light, so dead AP? I may swap in another AP which is working, but I think if I could reset the AP all may be well. Ubiquiti 24-24W POE injector wrong for Unifi 6 Lite AP? From STL renders to finished products, from hilts to accessories, it can be discussed here. In addition, I'm powering 3 Unifi cameras, 2 24v and 1 POE+ and I still have plenty of overhead to add more. If a run of the mill no brand China vendor allows headless firmware upgrades with USB based storage, why not Ubiquiti? The amount of time and money saved I'd Like to just use Ubiquiti Ap's with an OPNsense firewall router. Likely, your TL-SG108PE switch uses variant B, so the WAP doesn't work. The ports on the cisco will power any other device I plug into it (Meraki/Aerohive AP or Cisco Phone) but I had to use the supplied PoE injector to get the dome camera to work. iudz zcp aojx fjek mgczxop agji dyixsh rrmm vzmx efdak gdpe moefllsu xzfklgi skjg wotl